Silica gel products are formed by silica gel mold in the vulcanizing machine with high temperature. The general temperature is about 180---230 degrees. In the process of forming, it is mainly the reaction of vulcanization. At the same time, the silicone mold is also a special mold for making crafts. The characteristics of silica gel are high temperature resistance, corrosion resistance, strong tearing resistance and fine simulation. A special mold for all kinds of crafts.

The characteristics of silicone products manufacturers:

High temperature: the temperature range is -40 to 230 degrees Celsius. It can be used in microwave oven and oven. Silica gel products, silica gel cake box.

Yi Qingxi: silicone products produced by silica gel can be cleaned up after washing with clean water, and can also be washed in the dishwasher.

Long life: the chemical properties of silica gel are very untidy. The products made have longer life expectancy than other materials.

Softness and tranquility: thanks to the softness of silicone materials, the cake mold feels smooth, flexible and without distortion.

Color diversity: according to the needs of customers, can deploy different beautiful colors.

Environmental protection and non-toxic: from raw materials to finished products, no toxic or harmful substances are produced.

Electrical insulation function: silicone rubber has high electrical resistivity, and its resistance can remain in a wide temperature range and frequency range. At the same time, silica gel has good resistance to high voltage corona discharge and arc discharge, such as high voltage insulators, TV high voltage caps, electrical components and so on.

Custom-made silicone products are required to set up molds. The choice of mold form and the choice of die line are very important. There are three points:

1. It is convenient to take the mold.

Two, the mold line should be selected without affecting the overall effect of the product.

Three, does not affect the quality of products, such as some silicone miscellaneous pieces, especially now some silica gel daily necessities.

Different structures lead to different touch lines, and some product lines should be selected in the best position according to the appearance of the product, so the silicone products are not only conducive to production, but also very beautiful in appearance. There is also a high contact line because too high, resulting in waste rubber, and ultimately increase production costs. Thus reducing profits. The mold is opened well, the important step behind the sand blasting, the sand blasting process, not every set of mold are to be done in a regular way, a bit of mold does not need such tools, specific details will be answered for everyone later. Then the color of the silica gel is adjusted according to the formula.